How do I amend/set the programming of an Edel Heat Pump Cylinder?

Modified on Wed, 03 Apr 2024 at 02:59 PM

To amend a preset programmed or set a new programme, you will need to follow the below steps.

-    Press and hold the ‘CLOCK’ button for approximately 3 seconds.

-    Select the desired day you’d like to amend and press down on the dial.

-    Highlight ‘NEW PROG’ and press down on the dial.

-    You should then be able to amend the end of the first timed period.

It should show 00:00 - _ _ _ _ , you will just need to amend so the timings reflect the desired preferences.


Example: This example is based on end users showering/high hot water usage in the morning.  

0000-0800 ECO

0800-1200 COMF

1200-2100 ECO

2100-2400 COMF

If you would like to copy the programme to other days, highlight the ‘COPY SUN’ (this will be dependent on the day you have just set, could be MON, TUE, WED, THR, FRI, SAT or SUN), press down the dial, ‘COPY PROG’, press down the dial the ‘MODIFY PR’, press down the dial and then finally highlight ‘SEE PROG.’ and press the dial to see the existing programme.



-    Upon first use, we do recommend in the user manual, to set the first timed period to be set to ‘COMF’ mode. This is to allow both the heat pump and the immersion to heat the water to the desired temperature.

-    We also recommend the Edel to be set to comfort (COMF) mode from approximately 21:45 to 24:00 to ensure the Legionella Cycle can be completed. If the unit is not set to COMF, then ANTIBAC error will appear on the display. See below link if you get this error message.

Applicable Models:

EDL170-520RF, EDL200UK-630RF, EDL270UK-630RF


Was this article helpful?

That’s Great!

Thank you for your feedback

Sorry! We couldn't be helpful

Thank you for your feedback

Let us know how can we improve this article!

Select atleast one of the reasons
CAPTCHA verification is required.

Feedback sent

We appreciate your effort and will try to fix the article